P2800 Ford Auto Trouble Code

P2800 Ford Auto Trouble Code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

Some problems such as misfires and evaporative emission (EVAP) leaks can be very challenging to nail down. Misfires can be caused by ignition problems, fuel problems or compression problems. The underlying cause might be fouled spark plugs, bad plug wires, a weak ignition coil, dirty injectors, a shorted or open injector, low fuel pressure, a vacuum leak, a leaky head gasket, burned exhaust valve or a camshaft with a bad lobe.

P2800 Ford Possible Solution:

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

P2800 Ford Description For All Models :

P2800 Ford Trouble Repair :

With P2800 Ford code so start with the basics like a fuel pressure and fuel volume test. Or, you can start on the electrical side by doing a voltage drop on both the power and ground connections for the fuel pump. Some shops are reporting corrosion on the fuel pump ground that reduces power and fuel pressure.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120